Skip to content

Chapter 1 — Before You Start

Required Tools

You will need the following tools to assemble your DryBase:

  • Soldering iron (for heat-set inserts)
  • Phillips screwdriver
  • Hex key set
  • Wire cutters / flush cutters
  • Multimeter (recommended)

Safety Guidelines

Electrical Safety

The DryBase uses mains electricity. Never work on electrical connections while the unit is plugged in. Always double-check wiring before powering on for the first time.

High Temperature

The DryBase operates at temperatures up to 100°C. Allow the unit to cool completely before handling internal components after operation.

Kit Contents

Verify that your kit contains all listed components before starting assembly.

  • [ ] 150W Power Supply Unit (PSU)
  • [ ] C5 1.5m power cord (region-specific)
  • [ ] 3D-printed heating unit parts
  • [ ] 3.5-inch capacitive touch display
  • [ ] Cables
  • [ ] Drybox parts (both printed and non-printed)
  • [ ] Main board
  • [ ] Power board
  • [ ] Sensor board
  • [ ] Heating element
  • [ ] Exhaust fan
  • [ ] Blower fan
  • [ ] Adhesives bag
  • [ ] Screws / fasteners bag
  • [ ] Spares bag
  • [ ] 150W Power Supply Unit (PSU)
  • [ ] C5 1.5m power cord (region-specific)
  • [ ] 3.5-inch capacitive touch display
  • [ ] Cables
  • [ ] Drybox parts (non-printed only)
  • [ ] Main board
  • [ ] Power board
  • [ ] Sensor board
  • [ ] Heating element
  • [ ] Exhaust fan
  • [ ] Blower fan
  • [ ] Adhesives bag
  • [ ] Screws / fasteners bag
  • [ ] Spares bag

Missing or damaged parts?

Contact us at contact@filametric.com with your order number and a photo of the issue. We'll sort it out.

Next: Chapter 2 — 3D Printing